First, the characteristics

　　1, environmental protection and energy saving, can meet food-grade requirements (food grade FDA)

　　2, long service life, can run continuously for 20,000 hours;

　　3, unique design process, no maintenance, small size, long life, high efficiency, low power consumption;

　　4. The stator and circuit board of the pump motor are sealed with epoxy resin and safely isolated from the rotor, which solves the problem of water leakage caused by long-term diving of the motor-type DC water pump, which can be safely and safely waterproof underwater;

　　5, the same voltage can make a variety of parameters, such as 24v voltage can be made 2 meters lift, can also be made into 15 meters lift. The pump can be operated at a wide voltage, for example, a 24v pump can operate below 12v;

　　6. The shaft core of the pump adopts high-performance graphite bushing with high precision and good shock resistance. Because the pump adopts the precision matching of graphite bushing and zirconia, the noise is small, the noise of computer water-cooled pump (DS6001) and water-bed pump (DS6002) can reach below 23dB, almost achieving the mute effect;

　　7. The pump can realize voltage and PWM speed regulation and FG (analog) signal feedback;

　　8, can be customized according to the requirements of a variety of protection (blocking protection, polarity reverse connection protection, stuck protection, water shortage protection, etc.);

　　9, the pump has a variety of inlet and outlet sizes to meet your different needs;

　　10, multi-functional design, can be used for diving or non-diving (installation position is lower than the liquid level);

　　11, protection level: IP68;

　　12. Materials: ABS, PPS;

Remarks:

Maximum working temperature: 70 ° C -100 ° C

Application range:

　　Can be used in computer water cooling system, solar fountain, solar water heater, desktop fountain, crafts, coffee machine, water dispenser, tea maker, pourer, soilless cultivation, shower, small appliance application, kitchen and toilet equipment, medical equipment, water heater Pressurized, plumbing mattress, hot water circulation, swimming pool water circulation filtration, foot washing surf massage basin, surf massage bathtub, car cooling circulation system, car shower, oil-water separation and filtration equipment, lathe stamping, oiler, humidifier/air freshener , air conditioners, washing machines, medical equipment, cooling systems, sanitary products, water heater pumps, grassland irrigation, solar water circulation systems, other low noise requirements equipment.

Precautions:

　　1) When the pump casing is in contact with a hard object, a shock pad is attached to the outer casing or bottom of the water pump;

　　2) The water pump inlet pump body is installed in parallel with the horizontal plane for optimal installation effect;

　　3) The hose corners connected to the water inlet and outlet should not be less than 90 degrees as much as possible;

　　4) The pump can be installed at any angle of 360 degrees, but it should be contacted with the technical department of our company when ordering, so that the pump can be adjusted to the working state at the factory;

　　5) Stay away from the ferromagnetic physical environment;

　　6) It is strictly forbidden to use in water with impurities larger than 0.35mm. It should be filtered at the inlet of the pumping pipe, otherwise it will easily damage the water pump;

　　7) The positive and negative poles of the power supply cannot be reversed;

　　8) When the pump is working, the water inlet should be lower than the water level;

　　9) It is strictly forbidden to run the pump without water and no load, which will affect the life and noise of the pump;

　　10) The pump can be used for diving without diving, amphibious, and special attention when installing. If you don't understand, you can consult our after-sales technicians;

　　11) After transporting the medium which is easy to crystallize or precipitate, it should be flushed in time (after pumping, pump the water into the pump chamber, drain it after 1 minute) to ensure the service life of the submersible pump;